Step - by - Step How to

Skid Steer T-20 Transmission Assembly . Page 5 continued

 

Click HERE to order T-20 parts off our 6x6parts.com website

The T-20 Transmission first built by Borg-Warner, and ATV-O-MATIC, now built by Skid Steer Corp. has been used in thousands of Amphibious All Terrain Vehicles including Max II, Max IV, Attex, Hustler , Starcraft, Swamp Fox, Camel and many other manufactures. It as a popular choice of custom machine builders, since it gives forward, reverse, brakes, steering all within one unit.

When it's time for service, This Step-by-Step photo guide should answer most concerns.

We offer all replacement parts at Richard's Relices Click HERE for the parts pages.

Click HERE for a nice readable copy of the factory service manual in printable PDF form.

This page is designed to be printable by ROUTE6x6 and RICHARD'S RELICS

This is another addition to our new how to series, we will ba adding more every week, so check back often. You may also e-mail suggestions for future how - to's to. richard@route6x6.com

   
T-20 Assembly Step-by-Step guide Page 5 continued
   






C Ring installed.



Note: Red pointer location



Click on PHOTOS to see larger view

 


 

 


Orientate assembled case half as shown.

 

Click on PHOTOS to see larger view





Insure anchor pin locates in center plate and shown by red and yellow pointers,

 

 

Click on PHOTOS to see larger view

 

 

 

 

 

 

 

Sile R side case assembly over sun gear and shaft of L case.





Click on PHOTOS to see larger view

 

 

 

 

 

 

 

Going together, turn input shaft to locate sun gear in R case. Make sure band anchor pin locates in center plate.



Click on PHOTOS to see larger view

 

 

 

 

 

 

 

Hold cases together while installing bolt. Do not tighten at this point. Snug only.




Click on PHOTOS to see larger view

 

 

 

 

 

 

 

Turn case 180 degrees and install second bolt. only snug.





 


Click on PHOTOS to see larger view

 

 

 

 

 

 

Turn input shaft to insure gears have meshed.

Install remainder of bolts and tighten securely.

Insure input shaft still turns freely.


Click on PHOTOS to see larger view

 



 

 

 

 

 

 

Install bolts and keepers through brake levers and into plungers.

Repeat to install all four plunger bolts.



 

 

 

 

 

 

Ready for band adjustment

See BAND ADJUSTMENT section HERE




Click on PHOTOS to see larger view   



 

 

 

 

 

 

Install vented fill plug in R case

NOTE: As shown by red pointer.


 

 

 

 

 

 

 

 Install lower lever plug in L case, install fluid

Trans holds:

28oz of Dextron III
4oz of GM Rear end differental additive, this additive can be purchased at auto parts shops.

See CHECKING OIL LEVEL section HERE

Congratulations you are ready to install back in your machine.

Click on PHOTOS to see larger view   
   

Go back to PAGE 4

Go back to START OF ARTICLE PAGE 1
   

If you have any questions, you welcome to contact us at richard@route6x6.com
or call 812-944-1643 8am-6pm weekdays and will will help you.

Replacement parts available at RICHARD'S RELICS ATV Transmission parts page