| Author |
Message |
    
Rhino
New member
Username: Rhino
Post Number: 7
Registered: 08-2005
Posted From: 71.64.197.29
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, October 22, 2005 - 10:38 pm: | |
Well I picked up my ST400R that I've had stored at a buddies farm for the last 10 years. Sheesh, this thing needs some TLC. Does anyone have a gas tank or a picture of a tank. Also need the rubber molding that wraps around the body seam.
Thanks |
david berger
Advanced Member
Username: Davidrrrd
Post Number: 188
Registered: 01-2005
Posted From: 172.140.67.85
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, October 23, 2005 - 09:54 am: | |
i hope richard clark has that molding, but as for the tank i beleave you can get a recreativs maxII or maxIV gas tank into it. it would take some mods to the straps ect..ect..
this would also be a good question for mr clark, he has plenty of vehicles thereabouts and could probly have an employee trial fit a max tank in an attex just to be shure, good luck! |
Rhino
New member
Username: Rhino
Post Number: 8
Registered: 08-2005
Posted From: 71.64.197.29
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, October 23, 2005 - 10:42 pm: | |
Thanks Dave
I will try richard for the molding. I started the tear down today, seperated the body halves, powerwashed it etc. Does anyone know what drive belt I should have? I think it's a 69 or 70 with a 440 ccw engine. |
Don Kinyon
New member
Username: Oldnatva
Post Number: 9
Registered: 04-2002
Posted From: 69.172.32.158
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, October 24, 2005 - 01:21 pm: | |
Hey, Rhino;
Gates 6021 is what you should look for. Richard probably sells it, or a replacement for it.
Don |
Rhino
Junior Member
Username: Rhino
Post Number: 10
Registered: 08-2005
Posted From: 71.64.197.29
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, October 24, 2005 - 09:02 pm: | |
Thanks Don
I hate to wear out my welcome here since I'm new and all, but does anyone know the replacement part numbers for the inner and outer axle bearings? SKF, Bower, BCA etc??? Seals also?
And does anyone reproduce the decals for the attex?
Thanks |
Restoration of older ATV's