| Author |
Message |
    
Don Louchart
New member
Username: Mrcool
Post Number: 2
Registered: 09-2005
Posted From: 172.146.160.94
Rating: N/A
Votes: 0 (Vote!) | | Posted on Tuesday, September 27, 2005 - 10:42 pm: | |
I need to know if two flanges go on the outside of the tub and on on the inside between the frame and the tub |
Missouri's Max Dealer (Brandon Price)
Member
Username: Brandon_price
Post Number: 43
Registered: 01-2005
Posted From: 69.27.205.109
Rating: N/A
Votes: 0 (Vote!) | | Posted on Tuesday, September 27, 2005 - 11:34 pm: | |
The pair of bearing flanges will bolt to the outside of the body. None on the inside. |
david berger
Advanced Member
Username: Davidrrrd
Post Number: 158
Registered: 01-2005
Posted From: 172.155.214.89
Rating: N/A
Votes: 0 (Vote!) | | Posted on Wednesday, September 28, 2005 - 10:20 am: | |
don sometimes you find a single flanget half inside fraim so it's squair holes can hold carage bolts for a one wrench tightening from outside, otherwise as brandon has said the flangets hold your bearing on outside of the "tub"
if you know a machinest who can cut you new flangets to hold your bearings with same bolt pateren and such out of say 1/4" steal then a set of these will last a lifetime, i mention this because mine are the cheep stampings and have pounded out several sizes bigger and leak like crazy, the stamped steals ok for low powered slowly driven to church type vehicles though. |
Don Louchart
New member
Username: Mrcool
Post Number: 3
Registered: 09-2005
Posted From: 172.158.16.200
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, September 29, 2005 - 09:21 am: | |
thanks that helps |
Restoration of older ATV's