Route 6x6 Discussion Board: Need help for Amphicat

Route 6x6 Discussion Board Restoration of older ATV's Need help for Amphicat

< Previous Next >

Author

Message

Andre Grotrian

Rating: N/A
Votes: 0 (Vote!)

Posted on Wednesday, February 23, 2005 - 10:45 pm:

I have restored an 1967 Amphicat Serial Number 00045 and cannot seem to get the clutch plates and c bands adjusted in order to steer it left or right.It has an ODG gear box. If I pull back on either steer rod it stops both drive sides from rolling. Is there any literature to see if I reinstalled the unit correctly or adjusted it to tight? Any help would be greatly appreciated.Andre Grotrian

gpd4

Rating: N/A
Votes: 0 (Vote!)

Posted on Wednesday, February 23, 2005 - 10:45 pm:

It sounds like it's all too tight. You should get the books from Richard. There is a whole section on adjusting the tranny. You may think the price is a little high, but I got the whole set and don't regret spending a single penny of it. The engine manual and the service manual are priceless items for these machines.