| Author |
Message |
    
paul nygaard
New member
Username: Skypilot777
Post Number: 2
Registered: 07-2009
Rating: N/A
Votes: 0 (Vote!) | | Posted on Tuesday, July 07, 2009 - 11:21 pm: | 
|
hi everyone..
im a new argo vangard 2 owner..
1)i hav a bad inner bearing..(across from transmission)on the outer frame rail.
thanks for tips..im going to tackle it .
2)the rear chain tentioners are skewed off center it seems,the chain wears grooves diagonally across the blocks.is this normal????
and are the blocks cheap,, or can i make them easily from some stock.
.:::is there anyone that lives in the vancouver area that wants to earn a few bucks and give me a hand and advice in getting my machine in top shape??????...
anyone know of the best argo parts place in vancouver.bc
paul 604 7659853
skypilot340@hotmail.com
i look forward to recieving all your input .. |
Erich Kelter
Advanced Member
Username: Fisherman
Post Number: 117
Registered: 11-2005
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, July 09, 2009 - 07:22 am: |
|
1. If it's not in a bad state of corrosion, it shouldn't be hard to get the bearing out. The worst is bending your fingers around corners to get access.
2. The chain tensioners(Teflon pads)should sit straight. Rotate the metal part of the tensioner, then the pads can be popped off, they are a spimple press fit on the rotating shaft. Not expensive. |
paul nygaard
New member
Username: Skypilot777
Post Number: 4
Registered: 07-2009
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, July 18, 2009 - 03:52 am: |
|
thanks for tips...
paul |
|
Shop Talk: Tech Tips and Q&A section