Topics Topics Help/Instructions Help Edit Profile Profile Member List Register  
Search Last 1 | 3 | 7 Days Search Search Tree View Tree View  
Route 6x6 Discussion Board * Shop Talk: Tech Tips and Q&A section * 86 Argo with Tecumseh engine < Previous Next >

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

mark
New member
Username: Mpreiss

Post Number: 1
Registered: 10-2007

Rating: N/A
Votes: 0 (Vote!)

Posted on Saturday, October 13, 2007 - 10:23 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only) Ban Poster IP (Moderator/Admin only)

I have tried to start my argo this year, but for some reason am getting no spark at the spark plug. Can anyone tell me how to troubleshhot the ignition system to determine what has failed?
Top of pagePrevious messageNext messageBottom of page Link to this message

mike abbey
New member
Username: Mabbey38

Post Number: 1
Registered: 10-2007

Rating: N/A
Votes: 0 (Vote!)

Posted on Thursday, October 18, 2007 - 07:08 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only) Ban Poster IP (Moderator/Admin only)

check the plug,pull the magnito ground wire off at moterand test for spark if no spark its = in moter if you get spark its in wiring or switch,some of the less common problems magnets fell off fly wheel these are inside and glued with epoxy after 20 yrs the rust seems to push them off,there are also 2 pins that trigger the coil to fire one is long and one is short,if a mouse built a nest in the blower housing this pin or pins can break off you will have to remove blower housing to check,the long pin should only have .006 to .010 gap to coil make shur you gap the long pin to the coil or your first crank will break it off.if you remove the coil check the epoxy sealant in the back look for cracks that would let moisture in,check the stator to coil wire its just a .250x.032 push connector,if you remove the stator clean the mount and the laminated core [remove the rust] you might just clean it up and reset it and fix the problem,the magnets if the came off dont fret clean the surfaces get some 1/4 inch masonite and make spacers to go between magnts and use 5 min epoxy to reglue mags to flywheel, good luck

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Action: