Need help for Amphicat
Route 6x6 Discussion Board: Restoration of older ATV's: Need help for Amphicat
Top of pagePrevious messageNext messageBottom of pageLink to this message   By Andre Grotrian on Unrecorded Date: Edit

I have restored an 1967 Amphicat Serial Number 00045 and cannot seem to get the clutch plates and c bands adjusted in order to steer it left or right.It has an ODG gear box. If I pull back on either steer rod it stops both drive sides from rolling. Is there any literature to see if I reinstalled the unit correctly or adjusted it to tight? Any help would be greatly appreciated.Andre Grotrian

Top of pagePrevious messageNext messageBottom of pageLink to this message   By gpd4 on Unrecorded Date: Edit

It sounds like it's all too tight. You should get the books from Richard. There is a whole section on adjusting the tranny. You may think the price is a little high, but I got the whole set and don't regret spending a single penny of it. The engine manual and the service manual are priceless items for these machines.

Add a Message


This is a public posting area. If you do not have an account, enter your full name into the "Username" box and leave the "Password" box empty. Your e-mail address is optional.
Username:  
Password:
E-mail:

Administrator's Control Panel -- Board Moderators Only
Administer Page | Delete Conversation | Close Conversation | Move Conversation