T-20 fluid change
Route 6x6 Discussion Board: Shop Talk: Tech Tips and Q&A section: T-20 fluid change
  Subtopic Posts   Updated
Archive through November 10, 2000  2    
Top of pagePrevious messageNext messageBottom of pageLink to this message   By Pat Norman on Unrecorded Date: Edit

I have a oil suction tank to pull out my tranny fluid, but there is so little space to work in the back of a MAX IV. How do get fluid poured back into the fill hole ? Any suggestions welcome.

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Fred Sowerwine, Montana's Max Dealer (Fred4dot) on Unrecorded Date: Edit

Pat, I use one of those plastic honey bear squeeze containers. It has a wide opening for filling and small point for putting in the tranny. Mine is 12 oz. so the first bottle I just squirt in, the second bottle of 4 or less oz., I put in slowly until it runs out the "fill to" hole.

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Pat norman on Unrecorded Date: Edit

Thanks, good idea ! I have a short Frenchs Mustard container almost empty. It should work fine too.

Add a Message


This is a public posting area. If you do not have an account, enter your full name into the "Username" box and leave the "Password" box empty. Your e-mail address is optional.
Username:  
Password:
E-mail:

Administrator's Control Panel -- Board Moderators Only
Administer Page | Delete Conversation | Close Conversation | Move Conversation